3-Mode Precision Ignition Module *NEW*

This ignition module was developed to reliably offer multiple modes of operation without the use of a PIC (computer) chip. Running on 6-9 volts, this module is based on the 555 Timer, the world’s most popular IC chip.  It supports these modes:

• Single shot with auto-timeout   (click the links for associated YouTube video)

• Multiple shot (buzz) with auto-timeout  

• Buzz without auto-timeout  

The coil is energized for just 2-3 ms at a time and in auto-timeout mode:

• Eliminates any “dwell” setup requirements

• Increases efficiency of the coil which prolongs battery life

• Minimizes or eliminates chances of overheating the module or coil. 

For use with 6 to 12 volt batteries and coils, negative ground.  It even works with an alkaline 9v "smoke alarm" battery when paired with the 6/12v ATV Coil (COIL-UR).

Kit contains:

• Quality PCB made in the USA

• (1) ISL9V3040P3 IGBT or equivalent

• (1) 2N2222 Transistor or equivalent

• (6) Resistors

• (1) LED Timing Light

• (1) 8-PIN IC Socket

• (1) 555 Timer IC

• (4) Capacitors

• (3) Diodes

• (2) Removable Jumpers

• (2) 4 Position Screw Terminal Blocks 

Can be used with "points" or a Hall sensor & magnet setup (sold separately).  For points, note this module activates when points are CLOSED.  If you need a setup to fire when points  OPEN, check into using the TIM6.  

For hit & miss engines, order an extra Hall sensor and magnet if you wish to use the "spark saver" option.  This feature prevents the ignition from firing while the engine is "coasting", greatly increasing the life of your battery (details included in the instructions).

As always, bench test your entire system before installing on your engine!  

See our Blog for any 3PI module tips and tricks.

Complete assembly, installation and operation instructions below  (To print, click inside the document, then hit CTRL-P)