TIM6 Ignition Module

Kits from $17.50 

Assembled & Tested: $40.00

PCB Only $6.00

The TIM-6 is basically an amplifier.  It amplifies the signal from the Hall sensor several times until enough current can be sent to the coil (sold separately).  See the YouTube demo here --> https://youtu.be/_9KI5MJ0zQo

For use with 6 volt batteries (or 4.8 minimum to 7 volts maximum), negative ground, on most IC model engines.  The final TIP42C transistor switches the coil positive connection.

"Dwell" (the amount of time the board is energized during each cycle) must be controlled by the installer.  Too much dwell will prematurely drain your battery and possibly overheat the ignition module and coil.  See this link ==>  Dwell

Kit contains:

• (1) TIP42C Transistor

• (1) 2N2907A Transistor

• (4) Resistors

• (1) LED Timing Light

• (1) 3 Amp. 40 volt reverse polarity protection diode

• (1) Hall Effect Magnetic Sensor

• (1) Rare Earth Magnet,  1/8" dia x 1/16" thick (3.2mm x 1.6mm).

• (1) Printed Circuit Board (PCB) , 1.35" x 1.70".  

PLEASE NOTE: Due to component changes, some PCB holes will need to be drilled slightly larger.  Alternatively, some components like the diode can be "surface mounted".

Deluxe Kit - $21.00

Same as above, except also includes a PCB Screw Type Terminal Strip for ease of connecting or removing your battery, coil, and other wires.  Sometimes available fully assembled and tested for $40.00.  Click the down-arrow in the order box below.

PCB Only - $6.00

Got plenty of your own components, but just want the Printed Circuit Board?   Click the down-arrow in the order box below.